Questionable Status Group; Standard Event Status Group; Status Byte Register - Keysight Technologies 66332A Programming Manual

3 - Programming the DC Source

Questionable Status Group

The Questionable Status registers record signals that indicate abnormal operation of the dc source. As
shown in figure 3-7, the group consists of the same type of registers as the Status Operation group. The
outputs of the Questionable Status group are logically-ORed into the QUEStionable summary bit (3) of the

Status Byte register.

Register Command
Condition STAT:QUES:COND?
PTR Filter STAT:QUES:PTR <n>
NTR Filter STAT:QUES:NTR <n>
Event STAT:QUES:EVEN?
Enable STAT:QUES:ENAB <n>

Standard Event Status Group

This group consists of an Event register and an Enable register that are programmed by Common
commands. The Standard Event event register latches events relating to instrument communication status
(see figure 3-7). It is a read-only register that is cleared when read. The Standard Event enable register
functions similarly to the enable registers of the Operation and Questionable status groups.
Command Action
*ESE
programs specific bits in the Standard Event enable register.
*PSC ON
clears the Standard Event enable register at power-on.
*ESR?
reads and clears the Standard Event event register.
The PON (Power On) Bit
The PON bit in the Standard Event event register is set whenever the dc source is turned on. The most
common use for PON is to generate an SRQ at power-on following an unexpected loss of power. To do
this, bit 7 of the Standard Event enable register must be set so that a power-on event registers in the ESB
(Standard Event Summary Bit), bit 5 of the Service Request Enable register must be set to permit an SRQ
to be generated, and *PSC OFF must be sent. The commands to accomplish these conditions are:
*PSC OFF *ESE 128
Status Byte Register
This register summarizes the information from all other status groups as defined in the IEEE 488.2
Standard Digital Interface for Programmable Instrumentation. The bit configuration is shown in Table 3-1.
Command Action
*STB? reads the data in the register but does not clear it (returns MSS in bit 6)
serial poll clears RQS inside the register and returns it in bit position 6 of the response.
34
A register that holds real-time status of the circuits being
monitored. It is a read-only register.
A positive transistion filter that functions as described under
STAT:QUES:NTR|PTR commands in chapter 4. It is a
read/write register.
A negative transition filter that functions as described under
STAT:QUES:NTR|PTR commands in chapter 4. It is a
read/write register.
A register that latches any condition that is passed through the
PTR or NTR filters. It is a read-only register that is cleared
when read.
A register that functions as a mask for enabling specific bits
from the Event register. It is a read/write register..
*SRE 32
Description