Table of Contents
Advertisement
5-2-8. Blocks
By making block settings, multiple groups in a given block can be collectively monitored or operated.
Touch [Initial Settings] in the menu bar, and then touch [Blocks]. Register the groups to each block, and then touch
[Save Settings].
Note: Some settings may not be accessible if logged in as a building manager.
Note: If the system is connected to a TG-2000A, make or change the settings from the TG-2000A.
Note: The [Controller] setting will appear (only on the TE-200's LCD) when the [System Exp] setting on the [Unit Info.] screen is set
to [Expand]. Switch the [Controller] setting between [AE200] and [Exp1] through [Exp4] to make settings for each TE-200,
TE-50, and TW-50 individually.
Important
● Block settings for the TE-50/TW-50 must be made with the TE-50/TW-50 properly connected to ensure proper settings.
Those settings made without the connection of TE-50/TW-50 will not be reflected.
Controller
Select [AE] to make
settings for TE-200, and
select [1], [2], [3], or [4]
to make settings for each
TE-50/TW-50.
Block No.
Block name
Group No.
"TE-50 No. - Group No."
will appear if one or more
TE-50/TW-50 controllers are
connected.
Group registration
(1) Touch the "Block name" button to display the keyboard. Enter the group name in 20 alphanumeric or symbol
characters or less.
Note: The following characters cannot be used: <, >, &, ", or '
(2) Touch the "Group registration" button of the target block. A
screen to select the groups will appear.
Touch the group numbers to be registered. (The name of
the group that was touched last will appear.)
The selected group numbers will appear with an orange
frame. Touch again to deselect.
WT09304X01
72
Group name
Save Settings
Touch to save the changes
made.
Advertisement
Table of Contents
