Initial Settings - Mitsubishi Electric AE-200A Installation Manual

8. Initial settings

Initial settings need to be made for each AE-200 on the AE-200's LCD or the Web browser.
The table below explains how to make initial settings on the AE-200's LCD. Details about the initial settings are
covered in the AE-200 Instruction Book and the Instruction Book (Web Browser for Initial Settings).
The startup and initial setting procedures vary with the system configuration.
System configuration 1: System without connection to AE-50 controller
System configuration 2: System with connection to one or more AE-50 controllers
Procedure
Start-up
Date and time
settings
Unit information
settings
Network settings
Group settings
Other initial settings
Exiting the [Initial
Settings] screen
WT07137X01
(controlling 50 or fewer units of equipment)
(controlling more than 50 units of equipment)
System
configuration
1 2
① Turn on the power to the AE-50 controllers.
Make initial settings for the AE-50 controllers on the [Unit Info.] and [Network]
screens.
②
* The AE-50 will restart.
Turn on the power to the AE-200.
① ③
② ④ The language selection window will appear. Select the desired language.
The [Initial Settings] screen will appear.
(Once the initial settings have been made, the [Monitor/Operation] screen will
③ ⑤
appear when the unit is turned on. Touch the
Settings] screen if necessary.)
① ① Set the current date and time.
Make other settings as necessary, and touch [Save Settings].
② ②
① ① Touch the [Unit info.] tab in the [Initial Settings] menu.
② Set the [System Exp] setting to [Do not expand].
② Set the [System Exp] setting to [Expand].
③ ③ Make other settings as necessary, and touch [Save Settings].
① ① Touch the [Network] tab in the [Initial Settings] menu.
Set the AE-200's IP address and other necessary settings, and touch [Save
Settings].
②
* The AE-200 will restart.
Make sure that [AE200] is selected as [Controller], set the AE-200's IP address
and other necessary settings, and touch [Save Settings].
②
* The AE-200 will restart.
Touch the [AE200] button to change it to [AE(1–3)], set the AE-50's destination IP
addresses and other necessary settings, and touch [Save Settings].
③
* The AE-200 will restart.
① ① Touch the [Groups] tab in the [Initial Settings] menu.
② Make group settings for AE-200, and touch [Save Settings].
Make sure that [AE200] is selected as [Controller], make group settings for AE-200,
②
and touch [Save Settings].
Touch the [AE200] button to change it to [AE(1–3)], make group settings for AE-50
③
controllers, and touch [Save Settings].
Make the following settings as necessary.
● Interlock settings (interlocked operation between LOSSNAY and indoor units)
① ① ● Block settings
● Floor Layout settings
● User Information settings
① ① Touch the
Details
icon to return to the [Monitor/Operation] screen.
30
icon to bring up the [Initial