Good Read Delay - Newland FM515 Series User Manual

Good Read Delay

Good Read Delay sets the minimum amount of time before the scanner can read another barcode after a good read. This
parameter is programmable in 1ms increments from 1ms to 3,600,000ms. Scan the appropriate barcode below to enable
or disable the delay.
Enable Good Read Delay
To set the good read delay, scan the barcode below, then set the delay (from 1 to 3,600,000ms) by scanning the digit
barcode(s) then scanning the Save barcode from the Appendix.
Set the good read delay to 1,000ms:
1. Scan the Enter Setup barcode.
2. Scan the Good Read Delay barcode.
3. Scan the numeric barcodes "1", "0", "0" and "0" from the "Digit Barcodes" section in Appendix.
4. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
5. Scan the Exit Setup barcode.
39
Good Read Delay
Enter Setup
Disable Good Read Delay
** Exit Setup