Reread Timeout - Newland FM515 Series User Manual

Reread Timeout

Reread Timeout can avoid undesired rereading of same barcode in a given period of time. This feature is only applicable to
the Sense and Continuous modes.
To enable/disable the Reread Timeout, scan the appropriate barcode below.
Enable Reread Timeout: Do not allow the scanner to re-read same barcode before the reread timeout expires.
Disable Reread Timeout: Allow the scanner to re-read same barcode.
Enable Reread Timeout
The following parameter sets the time interval between two successive reads on same barcode. It is programmable in
1ms increments from 0ms to 3,600,000ms. When it is set to a value greater than 3,000, the timeout for rereading same
programming barcode is limited to 3,000ms.
Set the reread timeout to 1,000ms:
1.
2.
3.
4.
5.
37
Scan the Enter Setup barcode.
Scan the Reread Timeout barcode.
Scan the numeric barcodes "1", "0", "0" and "0" from the "Digit Barcodes" section in Appendix.
Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
Scan the Exit Setup barcode.
Reread Timeout
Enter Setup
Disable Reread Timeout
** Exit Setup