Download Print this page

PROAIM CINEMA P-W5R-GRND Assembly Manual page 18

32ft grand camera jib/crane package

Advertisement

Install 12 volt AC adapter (4 pin XLR) in the
socket of Joystick Box.
NOTE: Any 12 volt battery may operate this
Pan Tilt Head as long as the Connector and the
#1 Negative pin & #4 Positive pin of Cable
meet together.
(4 pin XLR) and controller cables are both
installed in the sockets of the joystick box.
Insert the joystick box into the weight rod.
CAUTION: The power specification we have
provided is as per 12volt. For this, we provide
a 12volt/3ampere regulated power adapter.
In case you use a voltage higher than 12V, it
will affect the performance and life of the
motor, and there is a high risk of the motor
getting damaged.
After inserting the joystick box into the
weight rod, tighten the knob properly to
secure it.
Spin-3 (3-Axis) Motorized Dutch Roll Pan Tilt
Head is properly assembled with jib section
Balancing Points
Follow these steps to Balance the Pan Tilt Head
Find the horizontal balance point of your camera by using 2 fingers of one hand while holding handle.
Mark this point on the side of the camera with chalk or tape.
Turn the unit on and move the tilt control until the camera plate is vertical.
Loosen the two screws holding tilt motor.
Grasp the motor and turn slightly to disengage gears.
Mount the camera to the camera plate with the screw provided.
Tighten by threading the nut up to the bottom of the camera plate securely.
Make sure your balance point previously marked with chalk or tape is in the middle of the plate.
Loosen the knob below the camera plate and slide the camera and plate up or down until the centre line
of your camera is about in the middle of the large gear. Now tighten knob.
If the camera is perfectly balanced it will stay in any position while motor gear is still unattached.
Grasp the motor and turn it back until the gears mesh.
Gently tighten motor screws.
Secure the camera.
NOTE: All reduction boxes have a small amount of backlash. The balancing of the camera will reduce the
backlash to a minimum making it felt at the top of the tilt.
.
18

Advertisement

loading