Table of Contents
Advertisement
Command
Number
115
Check Set-up Information: Returns status information for
the designated channel.
116
Check Long Sensor Name: Returns long sensor name.
117
Check Short Sensor Name: Returns short sensor name.
1998
Set LED Command: Turns LEDs on and off on command.
1999
Sound Command: Specifies length and frequency of CBL 2
sounds.
2001
Direct Output to Digital-Out Port: Outputs data to the
digital output port during a sampling run.
201
Archive Operations Command: Allows the calculator to
determine the contents of the CBL 2's FLASH memory.
Detailed information about each command is given below. The table following each
syntax lists valid values. Default values appear in boldface type.
Command 0
Syntax: {0}
This command has no parameters or options. Clears data memory back to power-up
state. Clears error information. Resets only the RAM; does not clear FLASH memory.
This command should be sent at the beginning of each program.
Command 1
This command sets up a channel for data collection. It has six syntaxes, as shown below.
Syntax: {1,0}
Clears all channels.
Syntax: {1 ,channel, 0}
Turns off the selected channel.
Channel
1-3 = Analog
11 = Sonic
21 = Digital Input
31 = Digital Output
CBL 2 Technical Reference
Command Description
Reset CBL 2 RAM
Channel Setup
See
Page
41
42
43
43
43
43
44
23
Advertisement
Table of Contents
