Table of Contents
Advertisement
CBL 2 Command Summary
The table below lists the commands you can use in writing programs for CBL 2.
Detailed explanations of each command and its syntax can be found beginning on the
page number shown in the third column.
Command
Number
0
Reset: Resets all channels to default conditions.
1
Channel Setup: sets up a channel for data collection.
2
Data Type: This command is not used and should not be
sent. It is included only for compatibility with older CBL
programs.
3
Trigger Setup: Sets up the trigger parameters for an
experiment.
4
Conversion Equation Setup (Analog Channels): Sets up
parameters to convert physical units measured by CBL 2 into
a more useful measurement unit such as Newtons or ¡C.
Sonic Temperature Compensation (Sonic Channel):
Sets the unit of measurement for sonic data.
5
Data Control: Selects the type of data to be retrieved, as
well as the starting and ending data points to be retrieved
by a TI calculator.
6
System Setup: Turns sound on or off; sets an ID number
for the CBL 2; selects a filter to be applied to data.
7
Request System Status: Generates and prepares to return
status information.
8
Request Channel Status: Generates and prepares to
return sensor type, last valid data, and last valid data
position for the requested channel.
9
Request Channel Data: Generates and prepares to return
one data point before sampling starts. Used to verify that
setup is correct.
10
Advanced Data Reduction: Sets up CBL 2 to process
certain time-intensive algorithms instead of processing them
in the calculator.
12
Digital Data Capture: Sets up the capture or measurement
of motion data from the digital input channel.
102
Power Control Command: Sets the power to always on;
power-saving; or designated power up.
22
Command Description
CBL 2 Technical Reference
See
Page
23
23
26
26
28
30
30
30
31
32
33
33
34
41
Advertisement
Table of Contents
