Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
5.3.4 Touch Panel Adjustment (Epson Artisan 800/Epson
Stylus Photo PX800FW/TX800FW only)
This section describes Touch Panel adjustment.
Purpose
This adjustment is made to adjust the relative positions between the Touch Panel
detection points and displaying positions on the Control Panel.
Things to be used
Touch pen (without a sharp end such as a plastic stick)
Adjustment procedure
� � � �
While in the special inspection mode, you can operate selection of
�
each menu, etc. by pressing the following areas on the touch panel.
� � �
Power Left side of the touch panel
� �
(Menu backward)
Figure 5-45. Panel Operation in Special Inspection Mode
1.
Turn on the printer in the special inspection mode.
Check Step1 (p226).)
2.
Select " Touch Screen Inspection" and press LCD.
Inspection Mode
Run:OK / Select:[LEFT][RIGHT]
1. Mechanism Inspection
2. Special Inspection
3. Fax Inspection
4. Touch Screen Inspection
5. Development Mode
Figure 5-46. Touch Panel Adjustment (1)
ADJUSTMENT
Right side of the touch panel
(Menu forward)
LCD (OK/Menu selection)
(See 5.2.8 Case Open Sensor
Adjustment without Using Adjustment Program
https://www.manualsbooks.com
3.
Select " Touch Screen Calibration" and press LCD.
Inspection Mode
Run:OK / Select:[LEFT][RIGHT]
1.
Touch Screen Calibration
2. Touch Screen Coordinates
Figure 5-47. Touch Panel Adjustment (2)
4.
Press LCD to display the adjustment screen. When aborting the adjustment, press
the area other than LCD.
Touch panel to coordinate them
Touch LCD area. [OK]
Touch area outside of LCD. [Cancel]
Figure 5-48. Touch Panel Adjustment (3)
Revision C
242
Confidential