Card Slot Assy (Artisan 700/Px700W/Tx700W) - Epson Stylus Photo PX700FW Service Manual

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
When replacing the Main Board, the MAC address need to be
� � � � �
� � � �
set if the EEPROM data could not be read from the old Main
�
Board. In this case, attach the new " Label, MAC address (Parts
� � � � �
� � � number: 1489232)" to the position shown in
execute " 5.2.6 "MAC Address Setting"
Figure 4-237. Position for the MAC Address Label
After removing/replacing the Main Board, make the specified
adjustments. (See
DISASSEMBLY/ASSEMBLY
Fig. 4-237
(p223)" .
Label, MAC address
Chapter 5 "ADJUSTMENT".)
Disassembly/reassembly procedures specific to Artisan 700/PX700W/TX700W
https://www.manualsbooks.com

4.3.2.3 Card Slot Assy (Artisan 700/PX700W/TX700W)

The disassembly/reassembly procedures for Artisan 800/
PX800FW/TX800FW differ from those of Artisan 700/
and
PX700W/TX700W, see
procedures.
The Card Slot Assy includes the SUB Board and the STG
Board.
When powering this product, high-voltage current may be applied
on the SUB Board. To prevent ELECTRIC SHOCK, do not touch
the SUB Board section when the power is ON.
If the shock should happen, the flowing current is very tiny, about a
few hundreds A, therefore it will not do any harm on the human
body.
Parts/Components need to be removed in advance:
Scanner Unit/Upper Left Housing/Paper Guide Top Assy/
Upper Housing/Hinge/Rear Right Housing/Right Housing/Main Board Unit/
CSIC Assy/Cartridge Box Unit/Ink Supply Tube Assy
Removal procedure
Remove the screws (x2) that secure the Card Slot Assy and remove the
1.
Grounding Plate.
Figure 4-238. Removing the Card Slot Assy (1)
4.2.3.5 "Card Slot Assy" (p123)
Card Slot Assy
Dowel & Groove
C.B.P. 3x8 (6±1Kgfcm)
Revision C
for the
Plate
199
Confidential