Epson Stylus Photo PX700FW Service Manual page 172

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
4.Remove the screws (x5) that secure the Rear Frame and the screws (x2) that
secure the CR Motor Holder, and remove the Rear Frame together with the
CR Motor Holder. (See Fig. 4-127,
Front side
Figure 4-145. Removing the Rear Frame (2)
DISASSEMBLY/ASSEMBLY
Fig. 4-145.)
Right side
Rear Frame
Rib & positioning hole
C.B.S. 3x6 (8±1Kgfcm)
https://www.manualsbooks.com
Align the ribs (x2) of the Rear Frame with the positioning holes
(x2) of the Main Frame. (See
Take care of the following points when installing the Torsion
Spring A, B and C.
Attach the Torsion Spring A (x4) to the ribs of the Main
Frame.
Attach the Torsion Spring B (x2) and C (x2) to the ribs of the
Rear Frame.
Align and attach the straight legs of the springs to the groove of
the Upper Paper Guide L/R.
Attach the hook-shaped legs to the hooks of the Rear Frame.
Rib of the Main Frame
Rib of the Rear Frame
Groove of the Upper Paper Guide L/R
Hook of the Rear Frame
Rear side
B
Disassembly Procedures
Fig. 4-145.)
A A C B A
Figure 4-146. Attaching the Torsion Spring
Revision C
A
B
A C
160
Confidential