Epson Stylus Photo PX700FW Service Manual page 139

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
1. Make sure of the installing condition and correct it if there is any gap. (See
4-62.)
2. Install the Head FFC to the Printhead. (See
3. Install the Printhead to the Carriage Unit, and secure it as follows:
When tightening the screws that secure the Printhead; to avoid
burring the slot, first align the screw to the hole, and turn it to
the left slightly to engage the threaded parts of the screw and
the hole correctly, then tighten it.
Make sure to follow the specified tightening torque.
When securing the Printhead, make sure to observe strictly the
following. Otherwise, the Printhead may be secured at an
angle, which may adversely affect the print quality.
3-1. Place the hand on the center of the Printhead, and align the screws (x3) with
the screw holes to temporary tighten the screws 1 and 2 alternately by 90
degrees slowly while pressing the Printhead in the direction of the arrow
shown in Fig. 4-63.
3-2. Tighten the screw 3 to the same level as the screws 1 and 2 before
completely tighten them.
3-3. Tighten the screws slowly by 90 degrees in the order shown in
to secure the Printhead.
Printhead
Figure 4-63. Assembling the Printhead (1)
DISASSEMBLY/ASSEMBLY
Fig.
4.2.4.1 Printhead Step5 (p125).)
Fig. 4-63
1) Place the hand lightly on
this point to press the
Printhead, and temporary
tighten the screws 1 and 2
alternately by 90 degrees.
2) Tighten the screw 3 to the
same level as the screws 1
and 2.
3) Tighten the screws slowly
by 90 degrees in the order
to secure the Printhead.
C.B.P. 2x10 (2.5Kgfcm)
Disassembly Procedures
https://www.manualsbooks.com
Make sure to install the Ink Supply Tube Assy after confirming that
the SEAL JOINT,H;B is surely attached on the joint point of the Ink
Supply Tube Assy to the Printhead.
The SEAL JOINT,H;B is not included in the new Ink Supply Holder
IC Assy, therefore, take out the SEAL JOINT,H;B from the old one
in advance, and attach it to the new one without any gap confirming
the correct direction to avoid installing it to the wrong holes.
Ink Supply Tube Assy
SEAL JOINT,H;B
Figure 4-64. SEAL JOINT,H;B
4. Insert the tip of the Ink Supply Tube screwing tool to the screw hole of the Ink
Supply Tube Assy.
Ink Supply Tube Assy
Figure 4-65. Assembling the Printhead (2)
Revision C
Joint point to the Printhead
Ink Supply Tube screwing tool
Screw hole
127
Confidential