Epson Stylus Photo PX700FW Service Manual page 210

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
Align the positioning holes (x2) on the Main Board with the
dowels (x2) of the Lower Shield Plate M/B. (See
Tighten the screws in the order given in
Align the dowels (x2) of the Lower Shield Plate M/B with the
grooves (x2) of the Upper Shield Plate M/B. (See
Align the positioning holes (x2) of the Main Board Unit with the
dowels (x2) of the Base Frame. (See
Align the dowels (x2) of the Main Board Unit with the
positioning holes (x2) of the Right Cable Frame. (See
4-232.)
Insert the rib (x1) of the Grounding Plate M/B to the hole of the
Main Board Unit, and align the positioning hole (x1) of the
Grounding Plate M/B with the dowel (x1) of the Main Board
Unit, and attach the Grounding Plate M/B. (See
4-235.)
Figure 4-235. Attaching the Grounding Plate M/B
DISASSEMBLY/ASSEMBLY
Fig. 4-234.)
Fig. 4-234.
Fig. 4-233.)
Fig. 4-232.)
Fig.
Fig. 4-232, Fig.
Hole
Rib
Disassembly/reassembly procedures specific to Artisan 700/PX700W/TX700W
https://www.manualsbooks.com
When replacing the Grounding Plate Sheet M/B, insert the
sheet between the FFC and the Main Frame, and secure it with
double-sided tape to the Grounding Plate M/B. (See
When attaching the Ferrite Core Holder A, follow the
procedure below.
Align the dowels (x2) of the Main Board Unit with the
positioning holes (x2) of the Holder IC Shield Plate.
Secure the Ferrite Core Holder A and the Holder IC Shield
Plate to the Main Board Unit with the screw. (See
4-231.)
When attaching the CR Encoder FFC, follow the procedures
below.
Put the CR Encoder FFC through the ferrite core.
Connect the CR Encoder FFC to the connector (CN6) on
the Main Board.
Insert the rib of the Ferrite Core Holder B to the hole of the
Main Board, and secure it with the screw (x1).
Align and insert the rib of
the Ferrite Core Holder B
CR Encoder FFC
Figure 4-236. Attaching the CR Encoder FFC
For routing the FFCs, see
4.4 "Routing FFC/cables"
Revision C
Fig. 4-230.)
Fig.
Ferrite Core Holder B
Ferrite core
C.B.S. 3x6 (5±0.5Kgfcm)
(p202).
198
Confidential