Table of Contents
Advertisement
4.6 Using the kit with the captive web portal
XPLR-HPG-1 includes pre-flashed, captive web portal software that allows access to GNSS correction
data from the Thingstream Point Perfect location service over Wi-Fi. Besides provisioning, the web
interface also supports a live map-tracking application for visualizing the location of XPLR-HPG-1 in
real time. The portal software can be used with
To start using the XPLR-HPG-1 kit with the captive portal software:
1.
Connect the XPLR-HPG-1 board to a computer using a USB-A to USB-C or USB-C to USB-C cable
on the UART J6_2 connector shown in
2.
With the kit connected to the computer, NORA-W106 should be available via the "Silicon Labs
CP210x UART Bridge" serial interface. Using this COMPORT, you can flash the board and monitor
the log messages.
3.
Follow the GitHub build instructions for "Live tracking map using a captive portal"
UBX-23000692 - R01
C1-Public
Use case #1
and
Use case
Figure
6.
Getting started
XPLR-HPG-1 - User guide
#3.
[17].
Page 35 of 37
Advertisement
Table of Contents
