Assembling The Enclosure - u-blox XPLR-HPG-1 User Manual

4.5 Assembling the enclosure

The C213 baseboard with mounted Click boards is designed to be inserted in a Takachi EXPF15-6-11
enclosure. To assemble the enclosure:
1. Insert the C213 baseboard with all mounted Click boards into the lowest possible position level
of the bottom assembly (item 3). Be sure to include the 18650 battery and the SIM card in their
respective positions on the C213 baseboard and the 4G LTE 2 Click board – if needed. These
holders are not accessible once the enclosure is fully assembled.
2. Fit the top assembly (item 2) on top of the bottom assembly (item 3)
3. Assemble the back assembly (item 1) and the back frame (item 4) using the four screws (item 7)
4. Assemble the front plexiglass surface (item 6) and front frame (item 8) using the four screws
(item 5)
Figure 27 shows the component parts of the enclosure.
Figure 27: Enclosure parts
Figure 28 shows how the C213 baseboard is seated in the bottom holder of the enclosure.
Figure 28: PCB placement in enclosure
UBX-23000692 - R01
C1-Public
Getting started
XPLR-HPG-1 - User guide
Page 34 of 37