Table of Contents
Advertisement
4
Getting started
The XPLR-HPG-1 explorer kit comes pre-assembled in a Takachi EXPF15-6-11 enclosure – with all
Click boards already mounted on the C213 baseboard. Simply
ready to use out-of-the-box.
☞
XPLR-HPG-1 does not include a battery or SIM card. As the holders for these components are
inaccessible when the kit is fully assembled, you must disassemble the kit to fit them – if needed.
See also
Inserting the SIM and
Figure 25: Kit enclosure showing access to antennas, buttons, switches, and connectors
4.1 Connecting the antennas
To start using the kit, simply connect the antennas:
1.
Connect the L-band antenna to the SMA connector of the LBAND RTK Click board
2.
Connect the GNSS antenna to the SMA connector of the GNSS RTK 2 Click board
3.
Connect the two LTE antennas to the SMA connectors of the 4G LTE 2 Click board
4.2 Inserting the MicroSD card
A MicroSD card (not included in the kit) is only required if you intend to record logfiles from the GNSS
RTK 2 Click board. An access hole in the protective plexiglass of the enclosure allows you to plug the
card directly into the holder, as shown in
4.3 Inserting the SIM and battery
The kit is ready to use out-of-the-box but must be reassembled for:
•
Cellular operation – requiring the installation of a SIM card (use case 2)
•
Standalone operation – requiring the installation of a battery
If either of these components are required in your application, you must disassemble the kit to fit
them.
UBX-23000692 - R01
C1-Public
battery.
Figure
25.
Getting started
XPLR-HPG-1 - User guide
connect the antennas
and the kit is
Page 31 of 37
Advertisement
Table of Contents
