Table of Contents
Advertisement
The following procedure is recommended for fitting these items collectively, but otherwise install only
those that are needed for your application design.
1.
Make sure that the battery connect switch is OFF (0).
2.
Disassemble the Takachi EXPF15-6-11 enclosure as shown in
3.
Remove the 4G LTE 2 Click board from the C213 baseboard.
4.
Insert the SIM to the nano card holder on the underside of the 4G LTE 2 Click board.
5.
Insert the 4G LTE 2 Click board back to the C213 baseboard.
6.
Include the 18650 battery in the battery holder.
7.
Assemble the kit again as shown in
UBX-23000692 - R01
C1-Public
Assembling the
enclosure.
Getting started
XPLR-HPG-1 - User guide
Assembling the
enclosure.
Page 32 of 37
Advertisement
Table of Contents
