1. Product Description
Controller
with stand
Adjustable
faceplate
Double linear
guide and rack
Note: Carriage length and depth can differ depending on motor and
gearbox type
Operating Procedure (as "go to" stop)
1.
Enter length to be cut into the position controller and press the Start
Button. Gauge arm now moves into position.
2.
Material is positioned through saw (or drill or punch) to desired length.
3.
Engage the saw material clamp.
4.
Retract gauge arm by pushing the Retract/Extend button.
5.
Cut the material.
6.
Remove the material.
7.
Disengage the saw clamp.
8.
Extend gauge arm by using the push button.
1.1 Intended Use
The only acceptable use for the PD100 is as a length gauging / feed system. Any
other use is not intended and is a misuse of the gauging system.
5
Carriage hood
Adjustable arm
(optional gripper)
RC conveyor