Kentucky PD1000 Instruction Manual page 19


Tighten all socket head cap screws of the joint rack on 1
guide section

Release clamp and move adapter rack, spacers and clamp to the
other end of the joint rack on 2

Mount joint rack to 2
with rack on 2
piece, the two metal spacers and the clamp

Tighten all socket head cap screws of the joint rack on 2
guide section

Mount T-slot connecting plate between 1
section to stabilize both sections. This T-slot connecting plate is
located inside the bottom T-slot of 2
Rack (bottom side)

Tighten now all socket head cap screws that connects conveyor with
2 nd aluminum guide section
5.1.7 Mount cable tray sections to aluminum guide

Required parts: cable tray sections (3" x 1" channel with brackets),
T-nuts and M8 bolts with washers
nd aluminum guide section and align joint rack
aluminum guide by using again the adapter rack
nd
1 st section
19
section of the aluminum guide
nd
and 2
st nd
nd aluminum guide section
2 nd section
aluminum
st
aluminum
nd
aluminum guide
T-slot connecting
plate