Kentucky PD1000 Instruction Manual page 18

5.1.5 Mount 2

Align 2 nd
horses and shims or some other appropriate means

Snap T-nuts into the T-slot facing the conveyor. For the Kentucky
Gauge conveyors series RC or RH use one T-nut every 18 inches
(recommended). Make sure to slide on enough T-nuts to any section
before mounting to conveyor

Mount 2
nd
screws with washers and stand-offs. Stand-off length is designed for
Kentucky Gauge conveyors series RC and RH and might not work
with different types of conveyors
Note: Do not tighten the screws at this point to be able to align the
T-nuts with the conveyor mounting holes and to be able to mount
the extra rack piece properly between both aluminum guide sections
5.1.6 Mount joint rack to aluminum guide sections

Remove pre-mounted rack screws from 1
aluminum guide

Mount joint rack to 1
adapter rack piece, the two metal spacers and a clamp
Pre-mounted
rack
aluminum guide section to conveyor
nd
section of the aluminum guide with the conveyor using saw
aluminum guide to conveyor by using M8 socket head cap
st aluminum guide section by using the short
Two spacers to
tighten clamp
properly
18
st and 2 nd
Pre-mounted screws to
mount joint rack to
connect aluminum guide
sections
Adapter rack
overlaps joint rack
and pre-mounted
rack for precise
alignment
section of
Extra joint rack to
connect both
aluminum guide
sections