Operator Training; Position Controller; Safety Measures; Danger By Electrical Power - Kentucky PD1000 Instruction Manual

Safety devices may be removed only
- when the machine is at a standstill
- after making sure that the machine cannot be run (i.e. removing power
to the controller).
When any component of the machine is replaced or removed the safety
devices must be properly installed and tested.
3.4

Operator Training

Only trained personnel can operate the machine.
The training requirements for assembling, operating, maintaining the machine
must be clearly defined. Personnel in training, must be accompanied by
trained personel.
Personnel
Job function
Operating
Troubleshooting
Repairing
Maintenance
3.5

Position Controller

Only trained personnel are allowed to use the position controller.
•
Only personnel with electronic training are allowed to open the position
•
controller.
3.6 Safety Measures for Gauge Use
• Only operate the machine when all the safety devices are working
properly and have been fully tested.
Before applying power be sure that nobody can be harmed by machine
•
movement or operation.
The machine must be checked at least once a day to check for
•
recognizable damage and proper function of the safety devices.
3.7

Danger by Electrical Power

Only properly trained and qualified electrical personnel shall work on
•
the power supply.
Check electrical devices frequently.
•
Immediately replace any loosed connection or cables that show wear.
•
All electrical panels keys and controller access codes must be stored in
•
a secure area with restricted access to unauthorized personel.
Trained
Operators
X
X
X
--
X...allowed --...not allowed
Mechanically
trained personnel
--
X
X
X
10
Electrically trained
personnel
--
X
X
X