Installation Procedure - Kentucky PD1000 Instruction Manual

5.1 Installation procedure

Controller
with stand
Adjustable
faceplate
Double linear
guide and rack
Note: carriage length and depth can differ depending on motor and
gearbox type
5.1.1 Packing list
- one or two sections of aluminum guide with double steel rods and
mounted rack (each section with pre-mounted T-nuts and bolts for
missing joint rack)
- one bag with T-nuts, M8 bolts, washers and stand-offs to mount
aluminum extrusion to conveyor
- one long piece of joint rack to connect both aluminum extrusion
sections (only when shipped in two separate sections)
- one 10in long adapter rack piece with two squared metal spacers to
properly align and tighten the separate joint rack with pre-mounted
racks on aluminum guide sections (only when shipped in two separate
sections)
- one motor carriage with yellow hood, stop arm with face plate
- cable track with cable and mating connectors to controller and carriage
- Sections of cable tray and mounting brackets with M8 socket head cap
screws with washers and T-nuts
- free standing control stand (optional)
- Position controller
Important: Please note that in some cases the machines are shipped
fully assembled (or nearly assembled) and require less joining hardware.
Contents may vary as application requires.
13
Carriage hood
Adjustable arm
(optional gripper)
RC conveyor