Kentucky PD1000 Instruction Manual page 20


Slide on the brackets and secure loosely by using the bottom T-nuts
in the slots of the aluminum extrusion. Align section 1 with far end
of aluminum extrusion (opposite side of the saw, drill, punch, etc.)

Space brackets properly at 8ft. Where channels meet, brackets will
be placed in close proximity. Sections supplied in 16ft sections max.
Fasten channels to brackets with provided hardware.

Tighten the socket head cap screws of each section from underneath
5.1.8 Assemble cable and cable track to carriage

Connect motor/brake and reader head cable from cable track to
mating connectors on carriage
4 pin connector for motor
and brake (tighten screw of
connector housing)
Mating connector
for reader head
20