3.8
Special Danger Zones
The Carriage and gauge arm.
•
The interface zone between the machine and the gauge.
•
3.9
Maintenance and Troubleshooting
Follow the maintenance and inspection schedule.
•
All operating mediums (i.e. air pressure) must be secured against
•
unintentional activation.
Unplug power cord any time for maintenance or repair.
•
Check all bolts if tightened correctly.
•
After finishing with maintenance check all safety devices before running
•
the machine.
3.10 Machine Design Changes
Do not change any mechanical or electrical components of the machine
•
without written manufacturer permittance.
Replace all non-working or damaged electrical components and
•
machine parts immediately.
Use only original parts and equipment from the manufacturer.
•
There is no warranty or liability if parts and equipment from different
•
suppliers are used.
3.11. Machine Cleaning and Disposal
Handle any lubricants properly especially
- When working with grease
- When working with chemicals.
3.12. Exposure to noise
The noise level produced by the gauging system is less than 70 dB (A).
•
Special safety and protection devices such as ear plugs or head phones
•
are not necessary for the gauge, but saws, drills and punches produce
such noise levels requiring hearing protection.
11