Kentucky PD1000 Instruction Manual page 26

Cleaning and maintaining the carriage

Do not remove any safety devices.

Remove chips and grease and any items that would be deemed in
the pathway of, or causing an unwanted obstruction of, the gauge
arm / carriage. This should be done several times per day when the
machine is in use.

Ensure that the hardware connecting the gauge arm to the carriage
and the cable track to the carriage are secured. This may be
checked on a quarterly basis or implemented in line with the
standard preventive maintenance schedules for the other equipment
in the facility.
Cleaning the double steel rods on aluminum extrusion

You may clean with compressed air along the double steel rods.

Add light machine oil lubricant in access of end cap labeled oil. This
will keep wipers and steel rods maintained with lubricant. This may
be checked on a quarterly basis or implemented in line with the
standard preventive maintenance schedules for the other equipment
in the facility.

Any questions or inquiries should be directed to our factory technical
department at 270-683-3500 ext.114.
Hymark Ltd. – 427 Bark Cove – Owensboro, KY 42303
(270) 683-3500 – Fax (270) 683-2500
26