Table of Contents
Advertisement
CONTROLS
Anti-trap mechanism
Principle
The jam protection prevents objects or body
parts from becoming jammed between the
roof frame and glass sunroof while the glass
sunroof is closing.
General information
If a resistance or blockage is detected while
the glass sunroof is closing, the closing opera-
tion is interrupted once the roof reaches the
half-open position, or it is stopped when clos-
ing from the tilted position.
Closing from the open position without
jam protection
If an external hazard or ice prevents normal
closure, proceed as follows:
1.
Close all doors.
2.
Switch on drive-ready state or stop a mov-
ing vehicle.
3.
Push the switch forward past the resistance
point and hold.
The glass sunroof closes with limited jam
protection. If the closing force exceeds a
specific threshold, closing is interrupted.
4.
Push the switch forward again past the re-
sistance point and hold until the glass sun-
roof closes without jam protection. Make
sure that the closing path is clear.
Closing from the lifted position without
jam protection
In case of danger from the outside or if icing
might prevent normal closing, proceed as fol-
lows:
100
Opening and closing
Online Edition for Part no. 01405A8A749 - VI/23
1.
Close all doors.
2.
Switch on drive-ready state or stop a mov-
ing vehicle.
3.
Push the switch forward past the resistance
point and hold.
Initializing after a power interruption
General information
After a power interruption during the opening
or closing process, the glass sunroof can only
be operated to a limited extent. Initializing the
system can help in this case.
The system can be initialized under the follow-
ing conditions:
▷
The vehicle is parked in a horizontal posi-
tion.
▷
The vehicle will not be moved until the initi-
alization is completed.
▷
The drive-ready state is established.
▷
The outside temperature is above
41 ℉/5 ℃.
During initialization, the glass sunroof closes
without the anti-trap mechanism.
Make sure that the closing path is clear.
Initializing the system
Press the switch up and hold
it until the initialization is com-
plete:
Initialization begins within 15 seconds.
Advertisement
Table of Contents
