Readjustments; Brake, Adjustment - Etac Cross 5 User Manual

Brake, adjustment

The brakes are infinitely settable.
1. Loosen the screw a couple of turns.
2. Set the brake in correct position.
3. The brake block should be 15-20 mm from the tyre
when the brake is not applied.
1
5 mm
4
If the rear wheel is positioned in one of the forward
settings it is possible for a leg support, when swung
to the side, to unlock an applied brake. To avoid this
the brake handle should be adjusted so that you
attain a "neutral" position. In this way the brake will
unlock first when the handle is pushed close to the
rear wheel.
Ph 1

9. Readjustments

4. Ensure that the brake is straight in the groove and
5. Ensure the nut locks on the inside.
2
5
1. Loosen the screw on the inside of the brake
handle.
2. Remove the oval plate, turn it 180° (the pin on the
3. Tighten it again.
1 2
tighten the screw. Test the brakes.
The braking effect is dependent on the air pres-
sure in the tyres. The brakes are parking brakes
and should not be applied during use.
plate's inside must sit in the upper hole).
3
39
Etac / Cross 5 / www.etac.com
3
15–20 mm