6. Place the crankshaft on the cylinder block.
7. Place the bed plate on the cylinder block.
• Standard liquid gasket : LOCTITE 5205, HYLOMAR3000, Dreibond 5105
• Check that the mating surfaces are clean and dry before applying liquid gasket.
• Apply liquid gasket in a 3mm wide bead without stopping.
• Assemble the bed plate in 5 minutes after applying the liquid gasket.
• After assembly, wait at least 30 minutes before filling the engine with oil.
8. Install the bed plate bolts.
• The bed plate bolts are tightened in 2 progressive steps.
• If any of the bed plate bolts in broken or deformed, replace it.