15. Install the intake and exhaust manifold.
16. Install the timing chain.
17. Install the drive belt.
DISASSEMBLY
1. Remove the valves.
(1) Using the SST (09222-28000, 09222-28100)(A), compress the valve spring and remove the retainer
lock.
(2) Remove the spring retainer.
(3) Remove the valve spring.
(4) Remove the valve.
(5) Using a needle-nose pliers, remove the stem oil seal.
INSPECTION
CYLINDER HEAD
1. Inspect for flatness.
Using a precision straight edge and feeler gauge, measure the surface the contacting the cylinder block and
the manifolds for warpage.
Flatness of cylinder head gasket surface :
Less than 0.03mm (0.0012in) for width
Less than 0.09mm (0.0035in) for length
Flatness of manifold mating surface :
Less than 0.025mm (0.0010in) for width
Less than 0.160mm (0.0063in) for length