Kia Cerato 2009 Service Manual page 120

Inspect the threads and O-ring(C). Wipe off the seat on the oil filter cap, then apply a light coat of oil to the oil filter
upper cap O-ring(C).
(3) Install the new oil filter by hand to the upper cap.
(4) After the rubber seal seats, tighten the oil filter clockwise.
Tightening torque :
24.5N.m(2.5kgf.m, 18.1lbf.ft)
3. Refill with engine oil.
(1) Clean and install the oil drain plug with a new gasket.
Tightening torque :
34.3 ~ 44.1N.m (3.5 ~ 4.5kgf.m, 25.3 ~ 32.5lbf.ft)
(2) Fill wih fresh engine oil.
Oil Capacity
Total : 5.7 L (6.02 US qt, 5.01 lmp qt)
Oil pan : 4.8 L (5.07 US qt, 4.22 lmp qt)
Drain and refill including oil filter : 5.3 L (5.60 US qt, 4.66 lmp qt)
Oil quality : ABOVE API CH-4 or ACEA B4 (with CPF:C3)
(3) Install the oil filler cap.
4. Start engine and check for oil leaks.
5. Recheck the engine oil level.
INSTALLATION
OIL PUMP
1. Install the oil pump.
(1) Place the inner and outer rotors into front case with the marks facing the oil pump cover side.
(2) Install the oil pump cover(A) to timing chain cover with the screws.
Tightening torque :
5.9 ~ 8.8N.m (0.6 ~ 0.9kgf.m, 4.3 ~ 6.5lbf.ft)
2. Check that the oil pump turns freely.
3. Install the timing chain cover.
4. Install the drive belts.
5. Fill with engine oil.
DISASSEMBLY
RELIEF PLUNGER