11. Remove the connecting rod cap(A).
Mark the connecting rod caps to be able to reassemble in the original position and direction.
12. Remove the piston and connecting rod assemblies.
(1) Using a ridge reamer, remove all the carbon from the top of the cylinder.
(2) Push the piston, connecting rod assembly and upper bearing through the top of the cylinder block.
• Keep the bearings, connecting rod and cap together.
• Arrange the piston and connecting rod assemblies in the correct order.
13. Lift the crankshaft(A) out of the engine, being careful not to damage journals.
Arrange the main bearings and thrust bearings in the correct order.