Ford SUPER DUTY 2024 Owner's Manual page 514

WARNING: Never place anything
between the vehicle jack and the ground.
WARNING: Do not attempt to
change a tire on the side of the vehicle
close to moving traffic. Pull far enough
off the road to not obstruct the flow of
traffic and avoid the danger of being hit
when operating the jack or changing the
wheel.
WARNING: The jack supplied with
this vehicle is only intended for changing
a flat tire in an emergency. Do not
attempt to do any other work on your
vehicle when it is supported by the jack,
as your vehicle could slip off the jack.
Failure to follow this instruction could
result in personal injury or death.
WARNING: Only use the spare
wheel carrier to stow wheels provided
with your vehicle.
Note: Do not use impact tools or power
tools operating at over 200 RPM on the
spare wheel carrier winch, which may cause
it to malfunction and result in the wheel and
tire not being securely stowed.
Note: Passengers should not remain in the
vehicle when the vehicle is being jacked.
1. Park the vehicle on a level firm ground
and activate the hazard flashers.
2. Apply the parking brake, place the
transmission in park (P), switch the
engine off.
3. Block the wheel diagonally opposite
the flat tire. If equipped, use the wheel
chocks attached to the tool bag. For
example, if the left front tire is flat,
block the right rear wheel.
2024 Super Duty (TFH) Canada/United States of America, enUSA, Edition date: 202307, DOM
Changing a Road Wheel
510
E388040
4. The jack is on the floor behind the
rearmost seat on the passenger side.
Turn the retainers counterclockwise to
remove the jack.
E309424
5. The took kit is on the floor under the
driver seat or under the rear seat on the
driver side. The tool kit could be
attached to the floor, inside the storage
bin, or attached to a bracket. Turn the
retainers counterclockwise to remove
the tool kit.