Ford SUPER DUTY 2024 Owner's Manual page 474

Note: Using non-recommended cleaners,
harsh cleaning products, chrome wheel
cleaners or abrasive materials could
damage wheel rims and covers.
Cleaning Running Boards
We recommend that you clean your
running boards in the following way:
1. Use a clean, soft, non-abrasive sponge
or brush to remove heavy deposits of
dirt.
2. Allow the cleaner to sit on the running
board surface for the time specified.
Rinse thoroughly with cold water.
3. For additional information and
assistance, contact an authorized
dealer.
Note: Do not leave the cleaner on longer
than the recommended wait time. This
could damage the running boards.
Note: Do not allow the cleaner to dry unless
instructed.
Note: Some car washes could damage the
running boards.
Note: Using non-recommended cleaners,
harsh cleaning products, chrome wheel
cleaners or abrasive materials could
damage the running boards.
CLEANING THE ENGINE
COMPARTMENT
Use a vacuum cleaner to remove debris
from the screen area below windshield.
Note: If you are not familiar with the parts
around the engine do not wash the engine
compartment. Avoid frequent engine
washes.
2024 Super Duty (TFH) Canada/United States of America, enUSA, Edition date: 202307, DOM
Vehicle Care
When washing the engine compartment:
• Never wash or rinse the engine while it
is hot or running.
• Never wash or rinse any ignition coil,
spark plug wire or spark plug well.
• Cover the battery, power distribution
box, and air filter assembly to prevent
water damage.
Note: If your vehicle has an engine cover
remove the cover before application of
shampoo and degreaser.
• Spray an approved engine shampoo
and degreaser on all parts that require
cleaning and rinse with water.
CLEANING STRIPES OR
GRAPHICS
It is recommended to wash your vehicle by
hand however, pressure washing may be
used under the following conditions:
• Use a spray with a minimum of 40°
wide spray angle pattern.
• Keep the nozzle 12 in (30 cm) and at a
90° angle to your vehicle.
• Do not use water pressure higher than
1,000 psi (6,895 kPa).
• Do not use water hotter than 73°F
(23°C).
Note: Holding the pressure washer nozzle
at an angle to the vehicle's surface may
damage graphics and cause the edges to
peel away.
CLEANING CAMERA LENSES AND
SENSORS
We recommend that you only use
lukewarm or cold water and a soft cloth
to clean the camera lens and sensors.
Note: Do not pressure wash camera lens
and sensors.
470