Table of Contents
Advertisement
Operation
Side scrubbing unit
(Fig. 11/1)
In order to complete work close to walls,
a pivoting side scrubbing unit, available
on option, can be installed at the front
right, refer to Section 3.1.9.
3.1.2 Squeegee
(Fig. 11/3)
The squeegee, which projects at the
sides, is fixed to the scrubber drier so
that it can pivot and swing. This enables
it to evade obstacles in the current track
and pivot back. Its strong suction ca-
pacity ensures the waste water is vacu-
umed up fully even on uneven floor and
in bends, leaving the floor dry enough to
be walked on. The squeegee must be
checked prior to starting work, when
disposing of waste water and/or filling
the solution tank and cleared of any for-
eign bodies which have been vacu-
umed up.
Check that the sealing strips are in per-
fect condition. The rollers serve to sup-
port the squeegee to prevent excessive
bending of the sealing strips. The
squeegee is automatically raised when
reversing.
3.1.3 Suction turbines (suction)
(Fig. 12/3)
The two suction turbines are located on
the rear panel of the solution tank and
can be accessed after opening the rear
doors. The suction turbines are
switched on and off automatically when
lowering and raising the squeegee, re-
spectively. A float switch in the recovery
tank switches the suction turbine off au-
tomatically on reaching the maximum
fill height.
25
Advertisement
Table of Contents
