Table of Contents
Advertisement
Operation
Service brake
(Fig. 16/5)
• In order to slow down the vehicle and
bring the scrubber drier to a stop,
tread on the foot pedal to the left of
the accelerator (as with a normal ve-
hicle) to actuate the hydraulic ser-
vice brake.
Drive direction switch
(forwards/reverse)
(Fig. 16/6)
• It serves to select the driving direc-
tion:
- Forward: control switch forward
- Reverse: control switch back
- Stop: control switch in center (neu-
tral position)
• To change the driving direction,
bring the vehicle to a stop by apply-
ing the service brake, select the new
direction and accelerate again.
36
Right-hand operating panel
(Fig. 16/7)
• This operating panel contains the
key switch to switch the vehicle on
and off, the horn and three switches
for the optionally available working
lights, spraying/vacuuming tool and
flashing beacon, also refer to sec-
tion 3.2.3.
Parking brake
(Fig. 16/8)
• The pedal to the left of the steering
column serves to apply the parking
brake to the rear wheels.
• When the parking brake is applied,
the corresponding control lamp on
the operating panel (Fig. 17/3) lights
up red.
• If the driving direction switch is actu-
ated while the parking brake is ap-
plied, a pulsating "beep" is issued.
Before getting out of the vehi-
cle apply the parking brake, set
the driving direction switch
(Fig. 16/6) to its neutral posi-
tion and switch the key switch
to off.
Advertisement
Table of Contents
