Table of Contents
Advertisement
S
S
UPER
ERVER 6013P-i Manual
Keyboard Port
Figure 6-1.
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected
to the JF2 connector on the motherboard to provide you with system status
indications. A ribbon cable has bundled these wires together to simplify the
connection. Connect the cable from JF2 on the motherboard to the appro-
priate header on the Control Panel PCB (printed circuit board). Make sure
the red wire plugs into pin 1 on both connectors. Pull all excess cabling out
of the airflow path.
The control panel LEDs inform you of system status.
System Interface" for details on the LEDs and the control panel buttons.
Details on JF2 can be found in "Chapter 5: Advanced Motherboard Installa-
tion."
IDE Drive Bays
(behind cover)
Mouse Port
Low Profile PCI Slot
USB Ports
COM1 Port
Chassis: Front and Rear Views
6-2
Control Panel
RESET
System Reset
Standard PCI Slot
Ethernet Ports
VGA Port
See "Chapter 3:
System LEDs
NIC 2
NIC 1
Main Power
Advertisement
Table of Contents
