Table of Contents
Advertisement
2-6
Checking the Drive Bay Setup
Next, you should check to make sure the hard drives have been properly
installed and all connections have been made.
1. Accessing the drive bays:
For servicing the hard drives, you will need to remove the top chassis
cover. If you need to remove or install hard drives, please refer to Chap-
ter 6.
2. Check the airflow:
Airflow is provided by two heavy duty 10-cm blower fans.
component layout was carefully designed to direct sufficient cooling air-
flow to the components that generate the most heat. Note that all power
and data cables have been routed in such a way that they do not block
the airflow generated by the fans.
3. Supplying power to the system:
The last thing you must do is to provide input power to the system. Plug
the power cord from the power supply unit into a high-quality power
strip that offers protection from electrical noise and power surges. It is
recommended that you use an uninterruptible power supply (UPS). Turn
on the power switch on the back of the power supply, then depress the
power button on the front chassis control panel.
Chapter 2: Server Installation
2-9
The system
Advertisement
Table of Contents
