Table of Contents
Advertisement
S
UPERSERVER 6013P-i User's Manual
5-9
Jumper Settings
Explanation of
Jumpers
To modify the operation of the
motherboard, jumpers can be
used
to
optional settings.
create shorts between two pins
to change the function of the
connector. Pin 1 is identified
with a square solder pad on
the printed circuit board. See
the motherboard layout pages
for jumper locations.
No te : On two pin jumpers,
"Closed" means the jumper is
on and "Open" means the
jumper is off the pins.
CMOS Clear
Refer to the table on the right for
the JBT1 jumper settings to clear
CMOS.
Always remove the AC
power cord from the system be-
fore clearing CMOS.
Note: For an ATX power supply,
you must completely shut down
the system, remove the AC power
cord and then use JBT1 to clear
CMOS. Replace JBT1 back to the
pin 1-2 position before powering
up the system again. Do not use
the PW_ON connector to clear
CMOS.
choose
between
Jumpers
Connector
Pins
Jumper
Cap
Setting
CMOS Clear Jumper Settings
Jumper
Position
1-2
2-3
Position
1-2
5-18
3
2
1
3
2
1
Pin 1-2 short
(JBT 1)
Definition
Normal
CMOS Clear
Position
2-3
Advertisement
Table of Contents
