Table of Contents
Advertisement
About This Manual
This manual is written for professional system integrators and PC techni-
cians.
It provides information for the installation and use of the Super-
Server 6013P-i. Installation and maintainance should be performed by ex-
perienced technicians only.
The SuperServer 6013P-i is an economical dual Xeon processor 1U
rackmount server based on the SC812L 1U rackmount server chassis and
the X5DPR-iG2 serverboard, which supports single or dual Xeon proces-
sors of up to 3.06 GHz at a Front Side (system) Bus speed of 533/400 MHz
and up to 12 GB of DDR-266 (PC2100) low-profile SDRAM memory.
Manual Organization
Chapter 1: Introduction
The first chapter provides a checklist of the main components included with
the server system and describes the main features of the SUPER X5DPR-
iG2 serverboard and the SC812L chassis, which make up the SuperServer
6013P-i.
Chapter 2: Server Installation
This chapter describes the steps necessary to install the SuperServer
6013P-i into a rack and check out the server configuration prior to powering
up the system. If your server was ordered without processor and memory
components, this chapter will refer you to the appropriate sections of the
manual for their installation.
Chapter 3: System Interface
Refer here for details on the system interface, which includes the functions
and information provided by the control panel on the chassis as well as
other LEDs located throughout the system.
Preface
iii
Preface
Advertisement
Table of Contents
