Table of Contents
Advertisement
Memory
The X5DPR-iG2 has 6 184-pin, DIMM slots that can support up to 12 GB of
low-profile, registered ECC DDR-266/200 (PC2100/1600) SDRAM. Module
sizes of 128 MB, 256 MB, 512 MB, 1 GB and 2 GB may be used to populate
the DIMM slots.
PCI Expansion Slots
The X5DPR-iG2 has one 64-bit, 133 MHz PCI-X slot and one slim 64-bit, 66
MHz PCI slot. A "butterfly" riser card is included with the server. This riser
card fits into the 133 MHz PCI-X slot and was designed specially for the
SC812L chassis to support the use of one standard PCI card and one low
profile (half-height, half-length) PCI card.
serverboard are used to change the speeds of these slots if needed (see
Chapter 5).
ATI Graphics Controller
The X5DPR-iG2 features an integrated ATI video controller based on the
Rage XL graphics chip.
AGP texturing. This onboard graphics package can provide a bandwidth of
up to 512 MB/sec over a 32-bit graphics memory bus.
Onboard Controllers/Ports
The X5DPR-iG2 includes one floppy drive controller and two onboard IDE
controllers, which support up to four hard drives or ATAPI devices.
Backpanel I/O ports include one COM port, two USB ports, PS/2 mouse and
keyboard ports, a VGA (monitor) port and one Intel 82546EB Gigabit Ethernet
controller for two LAN ports.
Other Features
Other onboard features are included to promote system health. These in-
clude various voltage monitors, two CPU temperature sensors, four fan
speed sensors, a chassis intrusion header, auto-switching voltage regula-
tors, chassis and CPU overheat sensors, virus protection and BIOS rescue.
Rage XL fully supports sideband addressing and
1-3
Chapter 1: Introduction
Several jumpers on the
Advertisement
Table of Contents
