Table of Contents
Advertisement
• When designing inlet and outlet, the following opening area shall be satisfied.
- Failure to do so may result in product problems, which are not warranted.
• If a separate case is installed on the vessel, design it with the recommended
opening area and aperture. Failure to meet the recommended aperture plane
and aperture ratio may cause the product to malfunction. In such cases, the
warranty does not apply.
• The partition should be in close contact with the case as well as with the enclosure
when installed.
• It is recommended that the inlet and outlet be located at the same position as the
enclosure.
• If possible, install ventilation openings around the inlet and outlet of the enclosure.
• If you install both sides or multiple units together, you must increase the opening
area by the number of installed units.
Installation Requirements
CAUTION
NOTE
21
Advertisement
Table of Contents
