Residual Risks - eka MKF 464 BM Installation And Maintenance Manual

Loss of "tightness" on the "nose" side
With the door open, loosen the locknut that secures the "nose" to its support; screw (clockwise) the
"nose" by a full turn so that the end (cross-shaped) piece is perfectly horizontal again; screw on the
previously loosened locknut. At the end of the operation, close the door, and check for slight resistance
when turning the handle: this means that the "front" gasket is pressing ("sealing") slightly on the inside
glass of the door.
If you do not feel any resistance, repeat the entire operation by screwing on the "nose" another full turn.
Warning
After performing all the operations necessary to restore the proper "sealing" of the gasket on the inside
glass of the door, check its tightness by running the oven: for at least 30 minutes, with a 100%
humidification cycle and with a cooking chamber temperature of 110°C. During oven operation no steam
must escape from the door.

4.7 Residual risks

Do not use the door handle to move the appliance: this may deform the door frame.
The appliance is fitted with electrical parts: it must never be washed with a water or steam spray.
The appliance is electrically connected: disconnect the power supply before performing any type
of maintenance.
To avoid incorrect connections of the appliance, the relevant electrical/water connections are
marked on the appliance by suitable identification plates.
Only for wheeled models
(MKF 1664 BM – MKF 2011 BM)
After installing the oven, ensure the tray trolley can be handled with ease, on smooth floors and
with no hindrance to insertion and extraction operations: the trolley is mounted on wheels, any
collision may cause the hot cooking food and/or liquids to spill and may even cause it to tip over.
14