Gas Connection - Vestfrost GBHV 10 User Manual

H
B
• Place the hob in the cut out. Mark the
location of the hob on the cooktop.
Marker
Hob
• Remove the hob. Place the gasket on
the line you marked. Make sure that the
line centres the gasket. Ensure that the
junctions overlap at the corners and no
gap is left along the sealing material.
Line you
marked
• Insert the appliance into the aperture
and fix in position using the brackets (A)
and screws (B). Adjust the position of
the brackets depending on the thickness
of the worktop and tighten the screws
evenly. Carefully trim away any excess
sealing material (C) from around the
appliance.
D
W
Separator
E
C1
E
C2
Worktop
Gasket
A

2.3 GaS ConneCtion

Assembly of gas supply and leakage
check
Connect the appliance in accordance
with applicable local and international
standards and regulations. First, check
what type of gas is installed on the cooker.
This information is available on a sticker
on the back of the cooker. You can find
the information related to appropriate gas
types and appropriate gas injectors in
the technical data table. Check that the
feeding gas pressure matches the values
on the technical data table, to be able to
get the most efficient use and to ensure the
minimum gas consumption. If the pressure
of used gas is different than the values
stated or is not stable in your area, it may
be necessary to assemble an available
pressure regulator on the gas inlet. You
should contact an authorised service centre
to make these adjustments.
Points that must be checked during
flexible hose assembly:
• If the gas connection is made by a
EN - 12
HOB
F
Separator
C
t
t>20
A
mm
B