Table of Contents
Advertisement
WARNING
m
Do not attempt to make any repair
m
to electric components or structural
components without contacting
Weber-Stephen Products LLC,
Customer Services Department.
Failure to use genuine Weber-
m
Stephen parts for any repair or
replacement will void all warranty
protection.
CALL
CUSTOMER
SERVICE
If you are still experiencing any
problems, contact the Customer Service
Representative in your area using the
contact information that can be
found on weber.com.
REPLACEMENT
PARTS
To obtain replacement parts, contact
the local retailer in your area or log
onto weber.com.
12
ELECTRIC BARBECUE DOES NOT TURN ON
SYMPTOM
• Heating element does not heat when following the instructions in the 'Operation' section of this
Owner's Manual.
CAUSE
The temperature controller may not be properly
inserted into the housing.
There is a problem with the power flowing from the
socket. The circuit breaker may have tripped to cause
a loss of power during use.
The current limiting circuit that is built-in to the
temperature controller may have interrupted the
power to the barbecue.
SOLUTION
Remove and reinstall temperature controller.
Always plug the temperature controller into the
barbecue before plugging power cable into the socket.
Identify other electrical devices that also lost power.
Unplug these devices while using your barbecue.
Check if different electrical outlets are available.
Refer to "Important Safegaurds" if extension cords are
needed.
If your circuit breaker continues to trip during use,
consult a qualified electrician.
If the temperature status indicator light is not on,
unplug the power cable from the socket in order to
'reset' the current limiting circuit. Wait 30 seconds,
then plug the power cable back into the socket.
Advertisement
Table of Contents
