Replacement Parts - Weber SUMMIT GC38 E Owner's Manual

Grill center

Hide thumbs Also See for SUMMIT GC38 E:

Assembly manual (52 pages)

Table Of Contents

Table of Contents

Cleaning the Grease Management System

The grease management system consists of an angled

slide-out grease tray and a catch pan. These components

were designed to be easily removed, cleaned, and

replaced; an essential step every time you prepare to grill.

Cleaning the Outside of the Grill

The outside of your grill may include stainless steel,

porcelain-enameled, and plastic surfaces. WEBER

recommends the following methods based on the

surface type.

Cleaning Stainless Steel Surfaces

Clean stainless steel using a non-toxic, non-abrasive

stainless steel cleaner or polish designed for use on

outdoor products and grills. Use a microfiber cloth to clean

in the direction of the grain of the stainless steel. Do not

use paper towels.

Note: Do not risk scratching your stainless steel with abrasive

pastes. Pastes do not clean or polish. They will change the

color of the metal by removing the top chromium oxide film

coating.

Cleaning Painted, Porcelain-Enameled Surfaces and

Plastic Components

Clean painted, porcelain-enameled and plastic

components with warm soapy water, and paper towels

or cloth. After wiping down the surfaces, rinse and dry

thoroughly.

Cleaning the Outside of Grills that are in Unique

Environments

If your grill is subject to a particularly harsh environment,

you will want to clean the outside more often. Acid rain,

pool chemicals, and salt water can cause surface rusting

to appear. Wipe down the outside of your grill with warm

soapy water. Follow up with a rinse and thorough drying.

Additionally, you may want to apply a stainless steel

cleaner weekly to prevent surface rust.

Cleaning the Inside of the Cabinet

Use a soft, damp cloth to wipe the interior of the cabinet.

Be careful not to pull any of the wire connections when

cleaning around the electronic components.

Replacing Batteries for the Battery Pack

Use alkaline batteries only. Do not mix old and new

batteries or different types of batteries (standard, alkaline,

or rechargeable). If you do not plan to use the grill for a

month or more, remove the batteries.

1) Locate the battery housing on the inside of the cabinet

on the bottom right side.

2) Press the tabs on the battery door to open (F).

3) Replace six size D batteries.

CAUTION: NEVER SPRAY THE GRILL WITH A STEADY WATER

STREAM SUCH AS FROM A GARDEN HOSE OR POWER

WASHER. ELECTRONIC COMPONENTS COULD BECOME

DAMAGED.

WARNING: Turn your grill off and wait for it to cool

before thoroughly cleaning.

WARNING: Over time, the development of rough

surfaces can form on the FLAVORIZER BARS.

Wearing gloves is recommended when handling.

Do not clean FLAVORIZER BARS or cooking grates

in a sink, dishwasher, or self-cleaning oven.

WARNING: When cleaning the burners, never use

a brush that has already been used to clean the

cooking grates. Never put sharp objects into the

burner port holes.

CAUTION: Do not place any grill components onto

the side tables as they may scratch the paint or

stainless steel surfaces.

CAUTION: Do not use any of the following to clean

your grill: abrasive stainless steel polishes or

paints, cleaners that contain acid, mineral spirits

or xylene, oven cleaner, abrasive cleansers

(kitchen cleansers), or abrasive cleaning pads.

Adjust Door Alignment

Each soft-close hinge is capable of adjustment in case it is

necessary to align the cabinet doors.

1) The front screw on the hinge body adjusts the door

horizontally, left and right (1).

2) The rear screw on the hinge body adjusts the depth of

the door, back and forth (2).

3) To adjust the door vertically, loosen the two screws on

the hinge bracket to slide the door up and down, then

retighten the screws (3).