Table of Contents
Advertisement
NOTE: Reference numbers and letters in parentheses
in the text refer to the callouts in the figures and
the parts drawings.
See page 33 for accessories available from
Graco. If you supply your own accessories, be
sure they are adequately sized and pressure-
rated to meet the system's requirements.
WARNING
Installing and servicing this equipment requires ac-
cess to parts which may cause electric shock or
other serious bodily injury if the work is not per-
formed properly. DO NOT install or service this
equipment or perform any of the following installa-
tion and adjustment procedures unless you are
trained and qualified.
WARNING
To prevent hazardous concentrations of toxic or
flammable vapors, spray only in a properly venti-
lated area. NEVER OPERATE THE SPRAY GUN
UNLESS VENTILATION FANS ARE OPERATING.
Check and follow all national, state, and local codes
regarding air exhaust velocity requirements.
The Typical Installation shown on page 6 is only a guide-
line for selecting and installing system components and
accessories, and is not an actual system design. Contact
your Graco representative or Graco Technical Assis-
tance (see back page) for assistance in designing a sys-
tem to suit your particular needs.
The following instructions generally presume a standard
system using pressure tanks to supply the paint compo-
nents and solvent, and air spray guns. See also "Option-
al System Arrangements" on page 8 for possible varia-
tions and their effect on the instructions.
Unpacking
Unpack the shipping carton(s), and compare the con-
tents to the packing list.
While unpacking, inspect the carton and the unit for any
signs of damage. Take note of any evidence of rough
handling during shipment. Immediately report any dam-
age to the carrier's claims agent, and also notify Graco
Customer Service (Tel. 708–671–8400).
If you find any damage, do not continue unpacking until
the PrecisionMix and shipping material have been in-
spected by the claims agent.
Location
Set the PrecisionMix on a strong table or workbench with
a level top surface. The unit weighs approximately 260
lbs (120 kg).
WARNING
The PrecisionMix is for use only in ordinary loca-
tions. DO NOT operate in hazardous locations, as
defined in Article 500 of the National Electrical Code
(USA).
INSTALLATION
Assemble the PrecisionMix
Refer to Fig. 4. Install the power card into the control pan-
el, in the slots provided.
SLOTS
TIGHTEN
TWO SCREWS
TO SECURE.
Fig. 4
Refer to Fig. 5. Screw the baffle into the opening in the
front of the mixing block, then screw in the integrator and
static mixer assembly.
INTEGRATOR
STATIC
MIXER
Fig. 5
Remove the keys for the control panel cover and the rear
control box, and store them in a safe place convenient to
the unit.
INTERNAL
FUSE
O–RING
BAFFLE
Advertisement
Table of Contents
