Replacing Report Printer Paper - Opex Envelopener Omation 306 Operator's Manual

- Wipe dust and debris from the sensors. Debris build-up can cause jams.
Accumulations of dirt and debris can cover sensors, preventing them
from working effectively. This will hinder machine performance.
3. Before carefully removing any chips or paper jammed in the cutter, unplug
the machine.
4. Empty the cutter trash bin. The mill cutter chips are collected in a trash bin
located in front of the operator's feet. The bin should be checked and
emptied on a regular basis. Failure to empty the trash bin will result in chips
"haystacking" up toward the cutter mechanism, preventing additional chips
from falling into the trash. This may lead to the cutter itself being jammed.
If this happens, empty the trash bin. Then clear the cutter so that no chips
remain, using a pencil or similar tool to push down chips which have
collected between the cutter and surrounding frame.

3.9.2. Replacing Report Printer Paper

The printer will automatically detect if it's out of paper. A "No paper in printer"
message will be displayed. The steps below describe how to replace printer
paper in the Model 306. The printer is accessed from the side of the machine.
1. Open the printer door. The printer drawer is hinged on the bottom. The
drawer will open and swing down on its hinge.
2. Check to see if the entire old roll of paper has fed through the printhead.
- If all of the paper is out of the printhead, go to step 4.
- If there is any paper remaining in the printhead, go to step 3.
3. Remove the remaining paper:
a. Do not attempt to pull the paper out of the printhead or try to feed the
paper through the printer rollers manually.
Operation
Omation® Model 306™ Envelopener® Operator Manual
OPEX Corporation use only - not for distribution
91