Installing The Fax/Modem - Epson ActionNote 866C User Manual

5. If you are finished installing internal components, replace
the keyboard as described on pages 4-15 to 4-16.
6. Run the Setup program, as described in Chapter 1, to update
your computer's configuration with the new
microprocessor.

Installing the Fax/Modem

If your computer did not come with the internal fax/ modem,
you can install it yourself. See the Introduction for information
about obtaining optional accessories for your ActionNote
computer.
Follow these steps to install the fax/ modem:
1. Remove the keyboard as described on pages 4-13 to 4-15
2. Refer to the illustration on page 4-25 to locate the fax/ modem
connector next to the power converter on the system board.
3. Remove the plastic insert covering the fax/ modem port
opening on the left side of the computer, next to the PC
card slots. Insert the tip of a screwdriver through the slot in
the plastic cover and carefully pry the cover off. You may
need to use gently increasing presure to break the cover
away from the case and push it out.
4-24 Installing Optional Devices