When To Run Setup; Starting The Program; Changing The Settings - Epson ActionNote 866C User Manual

When to Run Setup

Because your computer was set up and configured for you, the
configuration information may be correct for your needs.
However, you may want to run Setup to enter the correct time
and date, set a password, or customize the power management
features. In addition, any time you change the computer's
configuration (by installing or removing optional devices, for
example), you need to run Setup to update the configuration.

Starting the Program

To start Setup, make sure there is no diskette in the diskette
drive; then turn on your computer. (If your computer is already
on, exit any program you are using and press
reset the computer.) During power-on diagnostics you see the
following prompt at the bottom of your screen:
P r e s s F 8 t o r u n S E T U P
As soon as you see this message, press F8.
If you do not press F8 within 5 seconds, the computer loads
Windows. If this happens, exit Windows and press
to reset the computer.

Changing the Settings

When the computer starts Setup, you see the Page 1 screen,
which displays your computer's memory configuration in
addition to the settings you can change. Your total system
memory consists of the base memory plus extended memory.
Use the
option. Once you have highlighted an option you want to
change, press the + or --key as many times as necessary to
scroll through the settings and select the one you want. Press
PgDn or PgUp to go to the next or previous Setup screen.
1-10
Setting Up the Computer
keys to move the cursor from option to
Ctrl Alt Del
to
Ctrl Alt Del