Epson ActionNote 866C User Manual page 33

If you set a system password, the computer will prompt you to
enter it each time you turn on or reset your computer. If you set
a Setup password, the computer prompts you to enter it each
time you press F8 to run Setup.
Follow the instructions in the next sections to set, delete, or
change your password. Then see the instructions in Chapter 3
for entering your password when the system prompts you for
it.
Setting a pass word
Follow these steps to set a password:
1. Highlight the Password option. You see a warning and
message prompting you to press
2.
Press
password.
3. Type a password up to seven characters long. As you type,
you see only squares displayed on the screen.
4.
Press
password by entering it again.
5. Type the password again and press
incorrect password, you must start the process over again.
Keep trying until you have entered the password correctly
twice in a row.)
You see a message confirming your password installation
6. Press any key to continue. The Password option setting is
changed to Enabled.
1 - 1 4
Setting Up the Computer
Enter.
You see a message prompting you to enter a
Enter.
You see a message asking you to verify the
Enter.
Enter.
(If you enter an